CCNA - 1 Final Exam 2012 ~ CCNA Students....

CCNA - 1 Final exam

Network Fundamentals

01. When connectionless protocols are implemented at the lower layers of the OSI model, what is usually used to acknowledge that the data was received and to request the retransmission of missing data?

IP
UDP
Ethernet
a connectionless acknowledgement
an upper-layer, connection-oriented protocol or service

02. Refer to the exhibit. Each media link is labeled. What type of cable should be used to connect the different devices?

Connection 1 – rollover cable
Connection 2 – straight-through cable
Connection 3 – crossover cable

Connection 1 – crossover cable
Connection 2 – rollover cable
Connection 3 – crossover cable

Connection 1 – straight-through cable
Connection 2 – crossover cable
Connection 3 – crossover cable

Connection 1 – straight-through cable
Connection 2 – crossover cable
Connection 3 – straight-through cable

Connection 1 – crossover cable
Connection 2 – straight-through cable
Connection 3 – crossover cable

03. Which OSI layer does IP rely on to determine whether packets have been lost and to request retransmission?

application
presentation
session
transport

04. Refer to the exhibit. What is the correct destination socket number for a web page request from Host A to the web server?

00-08-a3-b6-ce-46
198.133.219.25:80
http://www.cisco.com
C 198.133.219.0/24 is directly connected, FastEthernet0/0

05. A PC can not connect to any remote websites, ping its default gateway, or ping a printer that is functioning properly on the local network segment. Which action will verify that the TCP/IP stack is functioning correctly on this PC?

Use the ipconfig /all command at the host’s command prompt.
Use the ping 127.0.0.1 command at the command prompt.
Use the traceroute command at the command prompt to identify any failures on the path to the gateway.
Use FTP to check for connectivity to remote sites.
Download a troubleshooting tool from the PC manufacturer’s website.

06. Which type of media is immune to EMI and RFI? (Choose two.)

10 Base-T
10 Base-2
10 Base-5
100 Base-FX
100 Base TX
1000 Base LX

07. Refer to the exhibit. The command that is shown was issued on a PC. What does the IP address 192.168.33.2 represent?

IP address of the host
default gateway of the host
IP address of the homepage for the host
primary domain name server for the host
IP address of the website resolver1.mooki.local

08. Refer to the exhibit. The diagram represents the process of sending email between clients. Select the list below that correctly identifies the component or protocol used at each numbered stage of the diagram.

1.MUA 2.MDA 3.MTA 4.SMTP 5.MTA 6.POP 7.MDA 8.MUA
1.MUA 2.POP 3.MDA 4.SMTP 5.MTA 6.MDA 7.SMTP 8.MUA
1.MUA 2.POP 3.SMTP 4.MDA 5.MTA 6.SMTP 7.POP 8.MUA
1.MDA 2.SMTP 3.MTA 4.SMTP 5.MTA 6.MUA 7.POP 8.MDA
1.MUA 2.SMTP 3.MTA 4.SMTP 5.MTA 6.MDA 7.POP 8.MUA

09. What is true regarding network layer addressing? (Choose three)

uses a flat structure
prevent broadcasts
heirarchical
uniquely identifies each host
48 bits in length
contains a network portion

10. Which OSI layers offers reliable, connection-oriented data communication services?

application
presentation
session
transport
network

11. Examine the graphic with current configurations. Host A in the Clerical offices failed and was replaced. Although a ping to 127.0.0.1 was successful, the replacement computer can not access the company network. What is the likely cause of the problem?

IP address incorrectly entered
network cables unplugged
subnet mask incorrectly entered
network card failure

12. Refer to the exhibit. Host A attempts to establish a TCP/IP session with host C. During this attempt, a frame was captured with the source MAC address 0050.7320.D632 and the destination MAC address 0030.8517.44C4. The packet inside the captured frame has an IP source address 192.168.7.5, and the destination IP address is 192.168.219.24. At which point in the network was this packet captured?

leaving host A
leaving ATL
leaving Dallas
leaving NYC

13. Refer to the exhibit. What two facts can be determined from the information that is given? (Choose two.)

This exchange is part of the three-way handshake.
The source port indicates that a Telnet session has been initiated.
The data is flowing from server to client.
The destination port indicates that an HTTP session has been initiated.
The data listed is associated with the transport layer.
The source port does not support communication with the destination port that is listed

14. Refer to the exhibit. On the basis of the IP configuration that is shown, what is the reason that Host A and Host B are unable to communicate outside the local network?

Host A was assigned a network address.
Host B was assigned a multicast address.
Host A and Host B belong to different networks.
The gateway address was assigned a broadcast address.

15. Which of the following are the address ranges of the private IP addresses? (Choose three.)

10.0.0.0 to 10.255.255.255
200.100.50.0 to 200.100.25.255
150.150.0.0 to 150.150.255.255
172.16.0.0 to 172.31.255.255
192.168.0.0 to 192.168.255.255
127.16.0.0 to 127.31.255.255

16. Which combination of network id and subnet mask correctly identifies all IP addresses from 172.16.128.0 through 172.16.159.255?

172.16.128.0 255.255.255.224
172.16.128.0 255.255.0.0
172.16.128.0 255.255.192.0
172.16.128.0 255.255.224.0
172.16.128.0 255.255.255.192

17. Which password is automatically encrypted when it is created?

vty
aux
console
enable secret
enable password

18. Which three statements characterize the transport layer protocols? (Choose three.)

TCP and UDP port numbers are used by application layer protocols.
TCP uses port numbers to provide reliable transportation of IP packets.
UDP uses windowing and acknowledgments for reliable transfer of data.
TCP uses windowing and sequencing to provide reliable transfer of data.
TCP is a connection-oriented protocol. UDP is a connectionless protocol.

19. When must a router serial interface be configured with the clock rate command?

when the interface is functioning as a DTE device
when the interface timers have been cleared
when the connected DTE device is shut down
when the interface is functioning as a DCE device

20. Which two functions of the OSI model occur at layer two? (Choose two.)

physical addressing
encoding
routing
cabling
media access control

21. A routing issue has occurred in you internetwork. Which of the following type of devices should be examined to isolate this error?

access point
host
hub
router
switch

22. Refer to the exhibit. With the router running NAT, what IP addresses can be applied to the computer to allow access to the Internet? (Choose three)

192.168.18.38
192.168.18.48
192.168.18.49
192.168.18.52
192.168.18.59
192.168.18.63

23. Due to a security violation, the router passwords must be changed. What information can be learned from the following configuration entries? (Choose two)

Router(config)# line vty 0 3

Router(config-line)# password c13c0

Router(config-line)# login